The sluice valve is a gate that controls the flow through the sluice. Typically employed to control water levels and flow in streams and canals, these gates are designed to be sealed in one direction. Wastewater treatment facilities can also use sluice gate valves.
A gate valve, also known as a sluice gate valve, is a type of valve that directs fluid flow into or out of a pipeline using a wedge-shaped disc as the gate. The disc of the gate valve is totally disconnected from the flow when the gate valve is fully opened. Practically negligible flow resistance is provided by this. As a result, relatively little pressure loss occurs as the fluid passes through the gate valve.
The most typical form of valve used in processing plants to handle slurries is the sluice gate valve. These valves are either fully opened or fully closed while they are in use.
Sluice gate valves cannot be utilised for throttling since precision is not possible. The partially open valve’s high flow velocity can generate noise, vibration, and surface erosion on the disc and seat.
A lifting gate or wedge is used to control the sluice gate valve so that water can flow freely. A hand wheel or motor at the stem’s top end raises and lowers the doors, and a circular or wedge-shaped gate blocks water flow at the stem’s bottom end. It has a threaded stem, thus to switch from the open to the closed position and back again to halt water hammering, the valve must be turned numerous times.
Sluice gate valves cannot be utilised as a flowing regulator and are frequently employed to stop liquid flow. The sluice valve’s absence from the flow route in the fully open position causes relatively little flow resistance. The diameter of the open flowing fluid typically fluctuates nonlinearly as you move the gate.
This demonstrates that the proposed rate does not change uniformly as the stem moves. A partly open gate will shake because of the liquid dynamics depending on the structure. Sluice valves are frequently utilised for bigger pipe sizes because they are easier to build than other huge button varieties.
A lifting gate or wedge is used to control the sluice gate valve so that water can flow freely. A hand wheel or motor at the stem’s top end raises and lowers the doors, and a circular or wedge-shaped gate blocks water flow at the stem’s bottom end. It has a threaded stem, thus to switch from the open to the closed position and back again to halt water hammering, the valve must be turned numerous times.
In a sluice valve, the gate is raised using one of two different spindle kinds.
Ascending Spherical Type Valve: This form of valve has a connection between the spindle/stem and the gate. The spindle valve raises with the spindle during operation rather than rotating with the handwheel.
Non-Raising Spindles Type Valve: In this kind of valve design, the gate is threaded internally where it is joined to the spindle and the spindle is threaded externally. The valve stem spins in its position during operation rather than rising from its position to lift the gate utilising connections.
For more information please checkout sluice valve malaysia